Citroen C3: Safety / i-Size child seats
i-Size child seats have two latches that engage on the two rings A.
These i-Size child seats also have:
- either an upper strap that is attached to ring B.
- or a support leg that rests on the vehicle floor, compatible with the
approved i-Size seat position.
Their role is to prevent the child seat from tipping forward in the event of
a collision.
For more information on the ISOFIX mountings, refer to the corresponding
section.
“ISOFIX" mountings
The seats shown below are fitted with ISOFIX
compliant mountings:
The mountings comprise three rings for each
seat, indicated by a marking:
Two rings A, located between the vehicle seat
backrest and cushion...
In compliance with European regulations, this table indicates the
possibilities for installing child seats secured using the seat belt and
universally approved
(a) as well as the largest ISOFIX and i-Size child seats
for the seat positions fitted with ISOFIX anchoring points in the
vehicle...
Other information:
An incorrectly installed
child seat
compromises the child's safety in the
event of an accident.
Ensure that there is no seat belt or seat belt
buckle under the child seat, as this could
destabilise it.
Remember to fasten the seat belts or the
harness of child seats, keeping the slack
relative to the child's body to a minimum,
even for short journeys...
USB port
Insert the USB memory stick into
the USB
port or connect the USB device to the
USB port using a suitable cable (not supplied).
To protect the system, do
not use a USB
hub.
The system builds playlists (in temporary
memory); this operation can take from a
few seconds to several minutes at the first
connection...