Citroen C3: Automatic gearbox / Switching the vehicle off
Before switching off the engine, it is possible to
engage position P or N to place the gearbox in
neutral.
In both cases, apply the parking brake to
immobilise the vehicle, unless it is programmed
to automatic mode.
If the selector is not in
position P, when
the driver's door is opened or
approximately 45 seconds after the ignition is
switched off, an audible signal sounds and a
message appears.
- Return the gear selector to P; the audible
signal stops and the message disappears.
To limit fuel consumption
during an
extended standstill with the engine
running (for example, in a traffic jam), set the
gear selector to N and apply the parking
brake...
In the event of a malfunction,
this warning
lamp comes on and a message is
displayed, when the ignition is switched on.
In this case, the gearbox goes into back-up
mode and is locked in 3rd gear...
Other information:
As a safety precaution, before leaving your
vehicle to set up and install the triangle, switch
on the hazard warning lamps and put on your
high visibility vest.
The triangle can be stored on the back panel of
the boot, attached with straps.
Assembling and placing the triangle
For versions supplied with a triangle as original
equipment, refer to the illustration above...
Eco-driving refers to a range of everyday
practices that allow the motorist to optimise their
fuel consumption and CO2emissions.
Optimise your use of the gearbox
With a manual gearbox, move off gently and
change up promptly. While accelerating, change
up early...