Citroen C3: Towing / Towing your vehicle

- On the front bumper, unclip the cover by
pressing at its left-hand side.
- Screw the towing eye in fully.
- Install the towbar.
- With a manual gearbox, move the gear lever
into neutral.
- With an automatic gearbox, move the gear
selector into position N.
Failure to observe this
instruction could
result in damage to certain components
(braking, transmission, etc.) and to the
absence of braking assistance the next time
the engine is started.
- Unlock the steering by turning the ignition key
one notch and release the parking brake.
- Switch on the hazard warning lamps on both
vehicles.
- Move off gently, drive slowly and only for a
short distance.
The towing eye is installed in the boot under the
floor.
For access:
Open the boot.
Lift up the floor and remove it.
Remove the towing eye from its housing...
On the rear bumper, unclip the cover by
pressing at the bottom.
Screw the towing eye in fully, until it reaches
a stop.
Install the tow bar.
Switch on the hazard warning lamps on both
vehicles...
Other information:
With the engine running:
In zone A, the temperature is correct.
In zone B, the temperature is too high; the
associated warning lamp and the central STOP
warning lamp come on in red on the instrument
panel, accompanied by the display of a message
and an audible signal...
Scan the QR Code on page 3
to view
explanatory videos.
Made up of a compressor and a sealant
cartridge, it allows you to carry out a temporary
repair of the tyre so that you can drive to the
nearest garage.
It is designed to repair most punctures located
on the tyre tread...